උපදෙස් අත්පොත

1. නිෂ්පාදන අවසන්view සහ අනුකූලතාව

This document provides instructions for the installation and use of the Fricparts replacement softener dispenser, designed for Kenmore washer model 110.22882101. This part is a direct replacement for the original equipment manufacturer (OEM) dispenser.

වැදගත්: Before proceeding with installation, verify that your washer's model number is 110.22882101 to ensure compatibility. Appliance parts can appear similar, so confirming the model number is crucial for correct fit and function.

2 ආරක්ෂිත තොරතුරු

• අවවාදයයි: Always disconnect the washer from its power source (unplug it or turn off the circuit breaker) before attempting any installation, repair, or maintenance. Failure to do so can result in electric shock, injury, or death.
• Wear appropriate personal protective equipment, such as gloves, to prevent injury during handling and installation.
• If you are unsure about any step of the installation process, consult a qualified appliance technician.
• කුඩා කොටස් දරුවන්ගෙන් ඈත් කරන්න.

3. පැකේජ අන්තර්ගතය

• 1 x Replacement Softener Dispenser (Fricpart-054588)

4. පිහිටුවීම සහ ස්ථාපනය

This section outlines the general steps for replacing the softener dispenser in your Kenmore washer. Specific steps may vary slightly depending on your washer's exact configuration.

1. බලය විසන්ධි කරන්න: Unplug the washer from the electrical outlet or turn off the circuit breaker supplying power to the washer.
2. ඩිස්පෙන්සරය වෙත පිවිසෙන්න: Open the washer lid. The softener dispenser is typically located in the center agitator or near the top rim of the wash tub.
3. Remove the Old Dispenser: Carefully pull or twist the old dispenser to remove it. Some dispensers may require a slight push down and twist motion to unlock. Observe how the old dispenser is seated to aid in installing the new one.
4. Install the New Dispenser: Align the new replacement softener dispenser with the opening. Gently push down and twist (if applicable) until it seats securely in place. Ensure it is firmly attached and does not wobble.

Image 1: The Fricparts replacement softener dispenser. This white cylindrical component features a central opening for fabric softener and a light blue ring at its base, indicating the 'PUSH DOWN' mechanism for secure installation or removal.

5. බලය නැවත සම්බන්ධ කරන්න: Plug the washer back into the electrical outlet or turn the circuit breaker back on.
6. පරීක්ෂණ මෙහෙයුම: Run a short cycle with water to ensure the dispenser is properly installed and there are no leaks.

5. මෙහෙයුම් උපදෙස්

Once installed, the softener dispenser operates as follows:

• පිරවීම: Pour the recommended amount of liquid fabric softener into the dispenser cup. Do not overfill beyond the 'MAX FILL' line, if indicated.
• බෙදා හැරීම: During the rinse cycle, the washer will automatically fill the dispenser with water, causing the softener to be diluted and dispensed into the wash tub.

6. නඩත්තු කිරීම

Regular cleaning of the softener dispenser is recommended to prevent buildup and ensure proper function.

• පිරිසිදු කිරීම: Periodically remove the dispenser from the washer (refer to installation steps for removal). Rinse it thoroughly under warm water to remove any fabric softener residue. Use a small brush if necessary to clean stubborn buildup.
• වියළීම: Allow the dispenser to air dry completely before reinstalling it.

7. දෝශ නිරාකරණය

If you encounter issues with your softener dispenser, consider the following:

• Softener Not Dispensing:
  • Ensure the dispenser is clean and free of clogs.
  • Check that the dispenser is correctly seated and sealed.
  • Verify that you are not overfilling the dispenser, which can prevent proper siphoning.
• Softener Dispensing Too Early/Late: This is typically controlled by the washer's internal mechanisms. Ensure the dispenser is correctly installed and not obstructed. If the issue persists, it may indicate a problem with the washer itself rather than the dispenser.

8. පිරිවිතර

• නිෂ්පාදන වර්ගය: Replacement Washer Softener Dispenser
• අනුකූල රෙදි සෝදන යන්ත්‍ර ආකෘතිය: කෙන්මෝර් 110.22882101
• නිෂ්පාදකයා: ෆ්‍රික්පාර්ට්ස්
• කොටස අංකය: FRIC-PL-APP-TP-22052025-022609 (Fricpart-054588)
• වර්ණය: Black/White (as per product description, actual visible part is white)
• අයිතම පැකේජ ප්රමාණය: 1

9. වගකීම් සහ සහාය

For warranty information or technical support regarding this replacement part, please contact the seller or manufacturer directly. Keep your purchase receipt and product information handy when contacting support.