1. හැඳින්වීම
This manual provides essential information for the safe assembly, operation, and maintenance of your Fire Sense 60262 Portable Tabletop Propane Patio Heater. Please read all instructions carefully before use and retain this manual for future reference.
Figure 1: Fire Sense 60262 Portable Tabletop Propane Patio Heater. This image displays the complete assembled unit, highlighting its stainless steel finish and compact design suitable for tabletop use.
2 ආරක්ෂිත තොරතුරු
අවවාදයයි: එළිමහන් භාවිතය සඳහා පමණි. මෙම හෝ වෙනත් උපකරණයක් අසල පෙට්රල් හෝ වෙනත් දැවෙනසුළු වාෂ්ප සහ ද්රව ගබඩා කිරීම හෝ භාවිතා නොකරන්න.
- Always operate the heater on a firm, level surface.
- Maintain adequate clearance from combustible materials.
- නිසි වාතාශ්රය සහතික කරන්න.
- ළමයින් සහ සුරතල් සතුන් හීටරයෙන් ඈත් කරන්න.
- ක්රියාත්මක වන විට කිසිවිටකත් හීටරය අවධානයෙන් තොරව තබන්න එපා.
- This heater is equipped with an auto shutoff tilt valve and an oxygen depletion sensor (ODS) for safety.
3. සැකසීම සහ එකලස් කිරීම
Your Fire Sense 60262 heater requires minimal assembly. Ensure all components are present and undamaged before proceeding.
3.1 සංරචක හඳුනාගැනීම
Refer to the packaging for a complete list of parts. Key components include the base, main pole, burner assembly, and reflector hood.
3.2 Propane Cylinder Installation
- Ensure the heater's control knob is in the 'OFF' position.
- Access the propane cylinder compartment located in the base of the heater. This typically involves unscrewing or opening a panel.
- Carefully screw a standard 1lb propane cylinder (not included) into the regulator connection. Hand-tighten only. Do not overtighten.
- මැදිරිය ආරක්ෂිතව වසා දමන්න.
Figure 2: Propane cylinder compartment. This image shows the internal compartment designed to hold a 1lb propane cylinder, accessible from the side of the heater's base.
Figure 3: Underside of the heater base. This view shows the sturdy base and potential mounting points for stability.
4. මෙහෙයුම් උපදෙස්
Follow these steps to safely ignite and operate your patio heater.
4.1 ජ්වලන ක්රියා පටිපාටිය
- Ensure the propane cylinder is correctly installed and the gas supply is open.
- Locate the control knob and the Piezo igniter button on the heater's body.
- Push and turn the control knob to the 'PILOT' position. Hold it down for 30-60 seconds to purge air from the gas lines.
- While still holding the control knob down, press the Piezo igniter button repeatedly until the pilot flame ignites. You may need to listen for a click and observe the pilot light through the viewing කුහරය.
- Once the pilot is lit, continue to hold the control knob down for another 10-15 seconds to allow the thermocouple to heat up. Release the knob slowly. If the pilot extinguishes, repeat steps 3-5.
- After the pilot is stable, turn the control knob to the desired heat setting (LOW to HIGH). The main burner will ignite.
Figure 4: Control panel. This image shows the control knob for adjusting heat and the Piezo igniter button for easy startup.
4.2 තාප සැකසුම් සකස් කිරීම
Rotate the control knob between 'LOW' and 'HIGH' to adjust the heat output according to your comfort level. The heater provides up to 10,000 BTU of heat.
Figure 5: Burner and heating grid. This close-up shows the stainless steel burner and protective grid, which glows red when operating at high heat.
4.3 තාපකය වසා දැමීම
To turn off the heater, rotate the control knob to the 'OFF' position. Ensure the gas supply from the propane cylinder is also closed when not in use.
4.4 නිල නිෂ්පාදන වීඩියෝව
Video 1: Fire Sense Propane Table Top Patio Heater, Stainless Steel. This video demonstrates the heater in an outdoor setting, showcasing its design and operation.
5. නඩත්තු කිරීම
නිතිපතා නඩත්තු කිරීම ඔබේ හීටරයේ ප්රශස්ත ක්රියාකාරිත්වය සහ කල්පැවැත්ම සහතික කරයි.
- පිරිසිදු කිරීම: Wipe the exterior surfaces gently with a damp රෙදි. උල්ෙල්ඛ පිරිසිදු කරන්නන් හෝ ද්රාවණ භාවිතා නොකරන්න.
- පරීක්ෂාව: Periodically check the gas hose and connections for any signs of wear, damage, or leaks. Perform a leak test with soapy water if a gas odor is detected.
- ගබඩා: When not in use, especially during off-season, disconnect the propane cylinder and store the heater in a cool, dry place, protected from weather elements.
6. දෝශ නිරාකරණය
ඔබේ හීටරය සමඟ ගැටළු ඇති වුවහොත්, පහත සඳහන් පොදු ගැටළු සහ විසඳුම් වෙත යොමු වන්න:
| ගැටලුව | විය හැකි හේතුව | විසඳුම |
|---|---|---|
| තාපකය දැල්වෙන්නේ නැත | No gas flow; Air in gas line; Faulty igniter | Check propane cylinder level and connection; Purge air by holding down control knob longer; Check igniter spark. |
| Pilot light will not stay lit | Thermocouple not heating sufficiently; Low gas pressure | Hold control knob down longer after pilot ignition; Check propane cylinder level. |
| Low flame or insufficient heat | අඩු වායු පීඩනය; අර්ධ වශයෙන් අවහිර වූ දාහකය | Check propane cylinder level; Ensure gas valve is fully open; Clean burner ports if necessary (when cool). |
| හීටරය අනපේක්ෂිත ලෙස ක්රියා විරහිත වේ | Tip-over switch activated; Oxygen depletion sensor activated | Ensure heater is on a stable, level surface; Check for proper ventilation. |
7. පිරිවිතර
- ආකෘතිය: 60262
- වෙළඳ නාමය: ෆයර් සෙන්ස්
- තාප ප්රතිදානය: 10,000 BTU
- ඉන්ධන වර්ගය: Propane (uses standard 1lb LP gas cylinder)
- ද්රව්ය: මල නොකන වානේ
- මානයන් (එකලස් කරන ලද): 13" Base, 21" Hood, 35" H
- බර: ආසන්න වශයෙන් රාත්තල් 17 කි
- ආරක්ෂිත විශේෂාංග: Auto Shutoff Tilt Valve, Oxygen Depletion Sensor (ODS)
- සහතික: CSA අනුමතයි
8 වගකීම් සහතිකය
This Fire Sense 60262 Portable Tabletop Propane Patio Heater comes with a වසර 1ක සීමිත වගකීමක්. Please retain your proof of purchase for warranty claims. For specific terms and conditions, refer to the warranty documentation included with your product or contact Fire Sense customer support.
9. සහාය
For further assistance, technical support, or to inquire about replacement parts, please contact Fire Sense customer service. Contact information can typically be found on the product packaging or the official Fire Sense webඅඩවිය.
