KitchenAid Architect Series II KSRS25RVMK ශීතකරණ පරිශීලක අත්පොත

වැදගත් ආරක්ෂක උපදෙස්

Your safety and the safety of others are very important. This manual provides important safety messages. Always read and obey all safety messages.

• ශීතකරණයක් භාවිතා කිරීමට පෙර සියලුම උපදෙස් කියවන්න.
• මෙම හෝ වෙනත් උපකරණයක් අසල පෙට්‍රල් හෝ වෙනත් දැවෙනසුළු වාෂ්ප සහ ද්‍රව ගබඩා කිරීම හෝ භාවිතා නොකරන්න.
• Do not allow children to climb, stand, or hang on the shelves of the refrigerator. They could damage the refrigerator and seriously injure themselves.
• පිරිසිදු කිරීමට හෝ නඩත්තු කිරීමට පෙර ශීතකරණය විසන්ධි කරන්න.
• විදුලි ආරක්ෂාව සඳහා නිසි බිම් සැකසීම සහතික කරන්න.
• වාතාශ්‍රය විවරයන්, උපකරණ ආවරණයේ හෝ ඉදි කර ඇති ව්‍යුහයේ, බාධාවකින් තොරව තබා ගන්න.

සැකසුම සහ ස්ථාපනය

ඇසුරුම් ඉවත් කිරීම සහ ස්ථානය

Remove all packaging materials, tape, and protective film from the refrigerator. Clean any adhesive residue with a soft cloth and warm water. Choose a location with a level floor, away from direct sunlight and heat sources. Allow at least 1/2 inch (1.27 cm) of space between the refrigerator and adjacent walls or cabinets for proper air circulation.

රූපය: ඉදිරිපස view of the KitchenAid Architect Series II KSRS25RVMK Side-by-Side Refrigerator. This image shows the overall design, including the dual doors and the external ice and water dispenser.

ශීතකරණය සමතලා කිරීම

It is crucial to level the refrigerator for proper door alignment and operation. Use a level to check the top of the refrigerator. Adjust the front leveling legs by turning them clockwise to raise or counter-clockwise to lower the refrigerator. Ensure both doors close and seal properly.

ජල සැපයුම් සම්බන්ධතාවය

A cold water supply is required for the ice maker and water dispenser. Connect the refrigerator to a potable water supply using a copper or braided stainless steel water line. Ensure the water pressure is between 30 and 120 psi (207 and 827 kPa). Flush the water system for 3-5 minutes before initial use to remove air and impurities.

සටහන: Refer to local plumbing codes for installation requirements. A water filter is pre-installed or needs to be installed before use.

මෙහෙයුම් උපදෙස්

උෂ්ණත්ව පාලන

The refrigerator and freezer compartments have separate temperature controls, typically located inside the fresh food compartment or on the external dispenser panel. The recommended temperature settings are 37°F (3°C) for the refrigerator and 0°F (-18°C) for the freezer. Allow 24 hours for the refrigerator to reach stable temperatures after initial setup or temperature adjustments.

අයිස් සහ ජල බෙදාහරින්නා

The external dispenser provides filtered water and cubed or crushed ice. To dispense water, press a glass against the water paddle. To dispense ice, select the desired ice type (cubed or crushed) and press a glass against the ice paddle. The first few batches of ice may contain air or impurities; discard them.

අගුළු විශේෂාංගය: The dispenser often includes a lock feature to prevent accidental dispensing, especially useful with children. Refer to your control panel for specific lock button location and operation.

Adjustable Shelves and Crisper Drawers

The refrigerator features cantilever spill-proof glass shelves that can be adjusted to various heights to accommodate different-sized items. To adjust, lift the front of the shelf and pull it out. Reinsert at the desired level. The humidity-controlled crisper drawers are designed to keep fruits and vegetables fresh. Adjust the humidity slider to high for leafy vegetables and low for fruits.

නඩත්තු කිරීම සහ රැකවරණය

ශීතකරණය පිරිසිදු කිරීම

Clean the interior and exterior of your refrigerator regularly. Unplug the appliance before cleaning. Use a mild detergent and warm water solution for interior surfaces. For stainless steel exteriors, use a stainless steel cleaner and polish, wiping in the direction of the grain. Do not use abrasive cleaners or harsh chemicals.

ජල පෙරහන ප්රතිස්ථාපනය කිරීම

The water filter should be replaced approximately every 6 months or when the "Replace Filter" indicator light illuminates, or water flow to the dispenser decreases significantly. The filter is typically located in the upper right corner of the fresh food compartment or in the base grille. Twist the old filter counter-clockwise to remove, then insert the new filter and twist clockwise until it locks into place. Flush the dispenser with 3-5 gallons of water after replacement to remove air and carbon fines.

Image: A placeholder for an image showing the location and process of replacing the water filter. If an image like "KSRS25RVMK_water_filter_replacement.jpg" were available, it would be placed here.

කන්ඩෙන්සර් දඟර පිරිසිදු කිරීම

For optimal efficiency, clean the condenser coils located behind the base grille at least once a year. Unplug the refrigerator. Remove the base grille and use a vacuum cleaner with a brush attachment to remove dust and debris from the coils. Replace the base grille and plug the refrigerator back in.

දෝශ නිරාකරණ මාර්ගෝපදේශය

සේවාව සඳහා ඇමතීමට පෙර, නැවතview this section. It may save you time and expense.

පිරිවිතර

වගකීම් සහ පාරිභෝගික සහාය

For detailed warranty information, please refer to the warranty card included with your appliance or visit the official KitchenAid webවෙබ් අඩවිය. වගකීම් හිමිකම් සඳහා ඔබේ මිලදී ගැනීමේ සාක්ෂි තබා ගන්න.

If you require assistance or service, please contact KitchenAid Customer Service. Have your model number (KSRS25RVMK) and serial number ready when you call.

• මාර්ගගත සහාය: පිවිසෙන්න www.kitchenaid.com/service-and-support
• දුරකථන සහාය: ඔබේ කලාපයේ සුදුසු සම්බන්ධතා අංකය සඳහා ඔබේ නිෂ්පාදන ලියාපදිංචි කිරීමේ ද්‍රව්‍ය වෙත යොමු වන්න.