1. හැඳින්වීම
The EHEIM Experience 250 is an external filter designed for freshwater aquariums ranging from 120 to 250 liters. This filter provides efficient mechanical, biological, and chemical filtration to maintain optimal water quality for your aquatic inhabitants. Its quiet operation and user-friendly design make it a reliable choice for aquarium enthusiasts.
This manual provides essential information for the safe and effective installation, operation, and maintenance of your EHEIM Experience 250 external filter. Please read all instructions carefully before use and retain this manual for future reference.
2. ආරක්ෂිත උපදෙස්
- Always disconnect the filter from the power supply before performing any maintenance, cleaning, or installation tasks.
- Ensure that the filter is placed below the water level of the aquarium to allow for proper water flow and priming.
- Do not operate the filter if the power cord or plug is damaged. Contact qualified personnel for repair.
- This appliance is intended for use with freshwater aquariums only.
- දරුවන්ට ළඟා විය නොහැකි ලෙස තබා ගන්න.
- Ensure all connections are secure and leak-free before powering on the unit.
3. පැකේජ අන්තර්ගතය
Verify that all components are present and undamaged upon unpacking. The package should contain:
- EHEIM Experience 250 Filter Unit
- Hose Adapter with Integrated Shut-off Valves
- Inlet Pipe with Strainer
- Outlet Pipe (Spray Bar)
- Hoses (2x)
- Suction Cups and Clips for Hose Mounting
- Filter Media Baskets (pre-filled with filter media)
- උපදෙස් අත්පොත
Image 1: EHEIM Experience 250 filter unit with all accessories, including hoses, inlet/outlet pipes, and suction cups.
4. පිහිටුවීම
- Prepare the Filter Media: පෙරහන් හිස rele මගින් විවෘත කරන්නasing the locking clips. Remove the filter baskets. Rinse any new filter media (e.g., sponges, ceramic rings) thoroughly under tap water to remove dust. Arrange the media in the baskets according to the manufacturer's recommendations (typically coarse mechanical at the bottom, fine mechanical/biological in the middle, chemical at the top).
- Assemble Inlet and Outlet Pipes: Attach the strainer to the inlet pipe and the spray bar to the outlet pipe. Use the provided suction cups and clips to secure these pipes inside your aquarium. Position the inlet pipe near the bottom of the aquarium and the outlet pipe near the surface for optimal water circulation.
- නල සම්බන්ධ කරන්න: Cut the hoses to the appropriate length, ensuring they are long enough to reach the filter unit without kinks. Connect one hose to the inlet pipe and the other to the outlet pipe inside the aquarium.
- Attach Hoses to Filter Head: Connect the hoses from the aquarium to the hose adapter on the filter head. Ensure the "IN" hose from the aquarium's inlet pipe connects to the "IN" port on the adapter, and the "OUT" hose from the aquarium's outlet pipe connects to the "OUT" port. Secure the hoses with the provided clamps.
- ආරක්ෂිත පෙරහන් හිස: Place the filter baskets back into the filter unit. Ensure the sealing gasket is correctly seated on the filter head. Carefully place the filter head onto the filter canister and secure it by engaging all locking clips firmly.
- පෙරහන ස්ථානගත කරන්න: Place the filter unit on a stable surface below the aquarium's water level. This is crucial for the filter to prime correctly and operate efficiently.
Image 2: Detail of the hose adapter on the filter head, indicating 'IN' and 'OUT' connections and valve levers.
5. ක්රියාත්මක වීම
- Fill the Filter with Water: Before connecting to power, ensure the filter is filled with water. Open both shut-off valves on the hose adapter. Water from the aquarium will flow into the filter by gravity. You may need to gently tilt the filter or use a priming aid (if available on your model) to remove air. Wait until water flows out of the outlet hose back into the aquarium, indicating the filter is full and primed.
- බලයට සම්බන්ධ කරන්න: Once the filter is fully primed and all connections are secure and leak-free, plug the power cord into a suitable electrical outlet. The pump will start, and water will begin circulating through the filter.
- Check for Leaks and Air: Observe the filter and hoses for any leaks. Listen for unusual noises, which may indicate trapped air. If air is present, gently tilt the filter unit to help release it.
- Adjust Flow (if applicable): Some models may have flow adjustment. Refer to specific instructions for your model if you wish to adjust the water flow rate.
6. නඩත්තු කිරීම
Regular maintenance is crucial for the longevity and efficiency of your EHEIM Experience 250 filter.
6.1. Cleaning the Filter Media
- බලය විසන්ධි කරන්න: Always unplug the filter from the power outlet.
- වෑල්ව වසා දමන්න: Close both shut-off valves on the hose adapter to prevent water from flowing out of the aquarium.
- හෝස් ඇඩැප්ටරය ඉවත් කරන්න: Disconnect the hose adapter from the filter head by lifting the locking handle.
- ප්රවාහන පෙරහන: Carefully carry the filter unit to a sink or bucket.
- Open Filter: Release the locking clips and remove the filter head.
- පිරිසිදු මාධ්ය: Remove the filter baskets. Rinse mechanical filter media (sponges, pads) in old aquarium water (not tap water) to preserve beneficial bacteria. Replace fine filter floss as needed. Biological media should only be gently rinsed if heavily clogged, again using old aquarium water.
- පිරිසිදු කැනිස්ටර් සහ හිස: Clean the inside of the filter canister and the impeller chamber in the filter head. Ensure the impeller is free of debris.
- නැවත එකලස් කරන්න: Reassemble the filter in reverse order. Ensure the O-ring on the filter head is clean and properly seated before securing the head with the clips.
- යළි අරඹන්න: Reconnect the hose adapter, open the valves, and prime the filter as described in the "Operating" section before plugging it back in.
6.2. Hose Cleaning
Hoses can accumulate biofilm over time, reducing flow. Clean hoses periodically (e.g., every 6-12 months) using a flexible hose brush. Disconnect hoses from both the filter and the aquarium for thorough cleaning.
7. දෝශ නිරාකරණය
| ගැටලුව | විය හැකි හේතුව | විසඳුම |
|---|---|---|
| Filter not starting / No water flow |
|
|
| ජල ප්රවාහය අඩු වීම |
|
|
| Loud noise / Vibrations |
|
|
| කාන්දු වීම |
|
|
8. පිරිවිතර
| විශේෂාංගය | විස්තර |
|---|---|
| ආකෘතිය | EHEIM Experience 250 |
| අයිතම ආදර්ශ අංකය | 2424020 |
| Aquariums සඳහා සුදුසු වේ | 120 - 250 Liters (Freshwater) |
| පොම්ප ප්රතිදානය | 700 L/H |
| Max Water Lift | මීටර් 1.5 |
| බලශක්ති පරිභෝජනය | වොට් 8 |
| පෙරහන් පරිමාව | 3 L |
| නිෂ්පාදන මානයන් (L x W x H) | 89 x 70 x 70 cm (Note: This dimension seems unusually large for a filter of this capacity, likely refers to packaging or a different product. The description states 340x178x178 mm which is more plausible for the filter unit itself. I will use the description's dimension for the filter unit and note the discrepancy.) |
| Filter Unit Dimensions (H x W x D) | 340 x 178 x 178 mm (අඟල් 13.4 x 7 x 7) |
| නිෂ්පාදන බර | 1 කිලෝ ග්රෑම් |
| නිෂ්පාදකයා | එහයිම් |
Note: Product dimensions from specifications (89 x 70 x 70 cm) appear to be incorrect or refer to packaging. The filter unit dimensions (340 x 178 x 178 mm) are derived from the product description and are more representative of the actual filter size.
9. වගකීම් සහ සහාය
For warranty information, technical support, or replacement parts, please refer to the official EHEIM website or contact your local EHEIM dealer. Keep your proof of purchase for warranty claims.
Official EHEIM Webඅඩවිය: www.eheim.com
