1. හැඳින්වීම
This manual provides detailed instructions for the installation, operation, and maintenance of your Braeburn Model 5220 Low Voltage Programmable Thermostat. This thermostat is designed for use with most 24 Volt AC heating and cooling systems, including single-stagඊ, බහු-එස්tage, and heat pump systems. It features a modern blue LCD display with touch button controls for easy programming and system management.
2 ආරක්ෂිත තොරතුරු
අවවාදයයි: Always turn off power to the heating and cooling system at the main fuse or circuit breaker panel before installing or servicing this thermostat. Failure to do so could result in electrical shock or equipment damage. Installation should be performed by a qualified technician if you are unsure about any steps.
- සියලුම රැහැන් දේශීය විදුලි කේත සහ ආඥාපනතවලට අනුකූල වන බවට සහතික වන්න.
- තාප ස්ථාය පරීක්ෂා කිරීම සඳහා ගෑස් කපාටයේ හෝ පද්ධති පාලනයේ පර්යන්ත කෙටි නොකරන්න. මෙය තාප ස්ථායයට හානි කරන අතර වගකීම් අවලංගු කරයි.
- මෙම උෂ්ණත්ව පාලකය අඩු වෝල්ටීයතාවයක් සඳහා නිර්මාණය කර ඇත.tage (18-30VAC) applications only.
3. පැකේජ අන්තර්ගතය
- Braeburn Model 5220 Thermostat
- බිත්ති තහඩුව
- සවි කිරීමේ දෘඩාංග (ඉස්කුරුප්පු සහ බිත්ති නැංගුරම්)
- ස්ථාපනය සහ මෙහෙයුම් අත්පොත (මෙම ලේඛනය)
- 2 AA ක්ෂාරීය බැටරි
4. ස්ථාපනය
4.1. සවිකරන ස්ථානය
Install the thermostat on an inside wall, approximately 5 feet (1.5m) above the floor. Avoid locations that are:
- Near windows or doors.
- Above or near heat-generating appliances.
- In direct sunlight or near heat sources.
- Near supply registers or return air ducts.
- In areas with poor air circulation.
4.2. පැරණි තාප ස්ථාය ඉවත් කිරීම
- බලය අක්රිය කරන්න to your heating and cooling system at the main fuse or circuit breaker.
- ඔබේ පැරණි තාප පාලකයේ කවරය ඉවත් කරන්න.
- Take a picture of the existing wiring connections for reference. This is crucial for correct installation.
- Disconnect the wires one by one, labeling each wire with the terminal designation it was connected to.
- Remove the old thermostat's mounting plate.
4.3. තාප ස්ථාය රැහැන් ඇදීම
Mount the new wall plate using the provided screws and anchors. Connect the wires to the corresponding terminals on the new thermostat's wall plate. Refer to the terminal designations below and your reference photo.
| පර්යන්තය | විස්තරය |
|---|---|
| RC | Cooling Transformer Power |
| RH | Heating Transformer Power |
| W2 | දෙවන එස්tagඊ තාපය (සාම්ප්රදායික) |
| W1/E/W3 | පළමු එස්tage Heat (Conventional) / Emergency Heat / Third Stage Heat (Heat Pump) |
| C | Common Wire (24VAC) |
| L | Fault Indicator (Heat Pump) |
| Y1 | පළමු එස්tage Cooling (Conventional) / Compressor (Heat Pump) |
| O/B/V3 | Reversing Valve (Heat Pump) / Third Stage Cooling (Conventional) |
| G | පංකා රිලේ |
| S2 | දුරස්ථ සංවේදක ආදානය |
| S1 | දුරස්ථ සංවේදක ආදානය |
After wiring, gently push any excess wire back into the wall opening. Attach the thermostat body to the wall plate.
4.4. බැටරි ස්ථාපනය
Insert the two AA alkaline batteries into the battery compartment, observing the correct polarity (+/-). The thermostat will power on and display initial settings.
බලය සක්රිය කරන්න to your heating and cooling system at the main fuse or circuit breaker.
5. මෙහෙයුම
5.1. Thermostat ඉවරයිview

This image displays the Braeburn Model 5220 thermostat. It features a white casing with a prominent blue backlit LCD screen. The screen shows a room temperature of 70 degrees Fahrenheit, a set temperature of 70 degrees, and the time as 12:00 PM. The system is set to 'HEAT ON' and the fan is on 'AUTO'. Below the screen are several control buttons: SYSTEM, DAY/TIME, PROG, HOLD, RETURN, and FAN. A vertical pair of up/down arrow buttons is located on the right side of the unit.
The Braeburn Model 5220 features a clear blue backlit LCD display and intuitive touch buttons for control. The display shows the current room temperature, the set temperature, the current time and day, and the active system and fan modes.
5.2. වත්මන් වේලාව සහ දිනය සැකසීම
- ඔබන්න දිනය/වේලාව බොත්තම. කාල සංදර්ශකය දැල්වෙනු ඇත.
- භාවිතා කරන්න UP or පහළට arrow buttons to adjust the time.
- ඔබන්න දිනය/වේලාව again to advance to setting the day.
- භාවිතා කරන්න UP or පහළට arrow buttons to select the current day.
- ඔබන්න ආපසු සුරැකීමට සහ පිටවීමට.
5.3. පද්ධති මාදිලිය තේරීම
ඔබන්න පද්ධතිය පවතින මාතයන් හරහා චක්රීය කිරීමට බොත්තම:
- අක්රියයි: තාපන සහ සිසිලන පද්ධතිය අක්රිය කරයි.
- තාපය: The thermostat will control the heating system.
- කූල්: The thermostat will control the cooling system.
- ස්වයංක්රීය: නියමිත උෂ්ණත්ව පරාසය පවත්වා ගැනීම සඳහා අවශ්ය පරිදි තාප ස්ථාය ස්වයංක්රීයව උණුසුම සහ සිසිලනය අතර මාරු වේ.
5.4. Fan Mode Selection
ඔබන්න රසිකයෙක් පවතින මාතයන් හරහා චක්රීය කිරීමට බොත්තම:
- ස්වයංක්රීය: විදුලි පංකාව ක්රියාත්මක වන්නේ උණුසුම හෝ සිසිලන පද්ධතිය ක්රියාකාරීව ක්රියාත්මක වන විට පමණි.
- මත: තාපන හෝ සිසිලන පද්ධතිය සක්රියද යන්න නොසලකා විදුලි පංකාව අඛණ්ඩව ක්රියාත්මක වේ.
5.5. උෂ්ණත්වය සකස් කිරීම
භාවිතා කරන්න UP or පහළට arrow buttons on the right side of the thermostat to adjust the desired set temperature. The new set temperature will flash and then become active.
5.6. ක්රමලේඛන කාලසටහන්
The Braeburn 5220 offers flexible programming options: 7-day, 5-2 day, 5-1-1 day, or non-programmable. It supports up to 4 temperature settings per day (Wake, Leave, Return, Sleep). Refer to the detailed programming instructions in the full manual for specific steps on setting up your desired schedule.
- ඔබන්න PROG ක්රමලේඛන මාදිලියට ඇතුළු වීමට බොත්තම.
- භාවිතා කරන්න UP or පහළට arrows and දිනය/වේලාව or PROG buttons to navigate and adjust program times and temperatures.
- ඔබන්න ආපසු to save and exit programming.
5.7. රඳවා ගැනීමේ කාර්යය
ද අල්ලා ගන්න button allows you to temporarily or permanently override the programmed schedule. Press අල්ලා ගන්න once to temporarily hold the current temperature until the next program period. Press අල්ලා ගන්න again to permanently hold the temperature until you press ආපසු රඳවා තබා ගැනීම අවලංගු කිරීමට.
6. නඩත්තු කිරීම
6.1. බැටරි ප්රතිස්ථාපනය
Replace the two AA alkaline batteries annually, or when the low battery indicator appears on the display. To replace, remove the thermostat from its wall plate, replace the batteries, and reattach the thermostat.
6.2 පිරිසිදු කිරීම
මෘදු, d තුණ්ඩයකින් තාප ස්ථායයේ බාහිර කොටස පිරිසිදු කරන්න.amp රෙදි. උල්ෙල්ඛ පිරිසිදු කරන්නන් හෝ ද්රාවණ භාවිතා නොකරන්න.
7. දෝශ නිරාකරණය
| ගැටලුව | විය හැකි හේතුව | විසඳුම |
|---|---|---|
| දර්ශනය හිස් ය | No power or dead batteries. | Check circuit breaker. Replace batteries. Ensure C-wire is connected if applicable. |
| තාපන/සිසිලන පද්ධතිය ප්රතිචාර නොදක්වයි | Incorrect wiring, system mode, or power issue. | Verify wiring connections. Check system mode (HEAT/COOL/AUTO). Ensure power is on. |
| උෂ්ණත්ව කියවීම් සාවද්ය බව පෙනේ | Thermostat location or internal sensor issue. | Ensure thermostat is not in direct sunlight or near heat sources. If problem persists, contact support. |
| Thermostat does not follow program schedule | Hold function active or incorrect programming. | ඔබන්න ආපසු to cancel any active hold. Review and re-program your schedule. |
For further assistance, refer to the complete Braeburn 5220 installation guide or contact Braeburn customer support.
8. පිරිවිතර
- ආකෘතිය: බ්රේබර්න් 5220
- වෙළුමtage: 18-30 වී.ඒ.සී.
- Stages Heat: 3 දක්වා
- Stagසිසිල්: 2 දක්වා
- වැඩසටහන්කරණය: 7-day, 5-2 day, 5-1-1 day, or Non-programmable
- Temperature Settings per Day: 4, 2, 1, හෝ 0
- පද්ධති මාරු කිරීම: Auto-Heat-Cool
- විදුලි පංකා මාරු කිරීම: ස්වයංක්රීයව ක්රියාත්මක වේ
- සංදර්ශක වර්ගය: නිල් පසුබිම් LCD
- සංදර්ශක ප්රමාණය: වර්ග අඩි 5
- යතුරු පෑඩ් ලොක out ට්: ඔව්
- වැඩසටහන්ගත කළ හැකි විදුලි පංකාව: ඔව්
- ස්වයංක්රීය මාරු කිරීම: ඔව්
- බලශක්ති ප්රභවය: 2 AA Alkaline Batteries (included) or 24VAC Common Wire
- සවිකිරීමේ වර්ගය: වෝල් මවුන්ට්
- මානයන්: ආසන්න වශයෙන් 6.25 x 5 x 2 අඟල් (පැකේජ මානයන්)
9. වගකීම් සහ සහාය
For warranty information and technical support, please contact Braeburn Systems LLC directly. Refer to the product packaging or the official Braeburn webවත්මන් සම්බන්ධතා විස්තර සහ වගකීම් කොන්දේසි සඳහා අඩවිය.
නිෂ්පාදකයා: BRAEBURN
UPC: 833732003229





