ECHO CS-590-20AA 20-inch 59.8 cc Gas Chainsaw Instruction Manual

හැඳින්වීම

This manual provides essential information for the safe and efficient operation, maintenance, and troubleshooting of your ECHO CS-590-20AA 20-inch 59.8 cc Gas Chainsaw. Please read this manual thoroughly before operating the chainsaw to ensure proper use and to prevent injury or damage.

ආරක්ෂිත තොරතුරු

Operating a chainsaw can be dangerous if proper safety precautions are not followed. Always wear appropriate personal protective equipment (PPE), including a helmet, eye protection, hearing protection, gloves, and chainsaw protective chaps. Ensure a clear work area and be aware of your surroundings. Never operate the chainsaw under the influence of alcohol or drugs. Refer to the full safety guidelines provided with your product for detailed instructions.

සැලසුම

1. Fueling the Chainsaw

The ECHO CS-590-20AA requires a specific fuel mixture of gasoline and 2-stroke engine oil. Always use fresh, unleaded gasoline with a minimum octane rating of 89 or higher. Mix the gasoline with high-quality 2-stroke engine oil at the ratio specified in your product's detailed manual (typically 50:1 for ECHO products, but always verify). Fill the fuel tank carefully, avoiding spills.

රූපය: ඉහළට view of the ECHO CS-590 chainsaw, highlighting the fuel and oil caps for easy access during fueling.

2. දාම තෙල් පිරවීම

The chainsaw requires bar and chain oil to lubricate the guide bar and saw chain during operation. Use a high-quality bar and chain oil. Fill the chain oil tank, ensuring it is not overfilled. Regularly check the chain oil level during operation.

Image: Close-up of the ECHO CS-590 chainsaw, showing the oil cap and the model number label.

මෙහෙයුම් උපදෙස්

1. එන්ජිම ආරම්භ කිරීම (සීතල ආරම්භය)

1. දම්වැල් කියත ස්ථිර, පැතලි මතුපිටක් මත තබන්න.
2. ඉදිරිපස අත් ආරක්ෂකය ඉදිරියට තල්ලු කිරීමෙන් දාම තිරිංගය යොදන්න.
3. Move the master control lever to the "COLD START" (choke) position.
4. ඉන්ධන ආපසු එන රේඛාවේ පෙනෙන තුරු ප්‍රයිමර් බල්බය කිහිප වතාවක් ඔබන්න.
5. Pull the starter handle firmly and quickly until the engine "pops" or attempts to start.
6. Move the master control lever to the "RUN" position.
7. එන්ජිම ආරම්භ වන තුරු ආරම්භක හසුරුව නැවත අදින්න.
8. Allow the engine to warm up for a few moments before disengaging the chain brake and beginning operation.

රූපය: සමීප රූපය view of the starter handle on the ECHO CS-590 chainsaw, used for manual engine ignition.

2. Starting the Engine (Warm Start)

1. දාම තිරිංග සම්බන්ධ කරන්න.
2. Move the master control lever to the "RUN" position.
3. Pull the starter handle firmly and quickly until the engine starts.

3. එන්ජිම නතර කිරීම

To stop the engine, move the master control lever to the "STOP" position. Ensure the chain has come to a complete stop before setting the chainsaw down.

Image: Close-up of the rear handle and the red stop switch on the ECHO CS-590 chainsaw.

4. මූලික කැපුම් ශිල්පීය ක්‍රම

• වැටීම: Plan your felling direction, clear the area, and make proper felling cuts (notch and back cut).
• අත් පා තැබීම: වැටුණු ගසකින් අතු ඉවත් කරන්න. මුලින්ම කුඩා අතු කපා, පාදමේ සිට ඉහළට වැඩ කරන්න.
• බක් කිරීම: Cut a fallen log into shorter sections. Be aware of tension and compression in the wood to avoid pinching the bar or kickback.

නඩත්තු කිරීම

Regular maintenance ensures the longevity and safe operation of your chainsaw. Always disconnect the spark plug wire before performing any maintenance.

• දාම තියුණු කිරීම: Keep the saw chain sharp for efficient and safe cutting. Use a round file of the correct diameter for your chain.
• මාර්ගෝපදේශ තීරු නඩත්තුව: Clean the guide bar groove and oil holes regularly. Flip the bar periodically to ensure even wear.
• වායු පෙරහන පිරිසිදු කිරීම: Clean the air filter frequently, especially in dusty conditions, to maintain engine performance.
• ස්පාර්ක් ප්ලග් පරීක්ෂාව: Inspect and clean the spark plug periodically. Replace if electrodes are worn or fouled.
• සාමාන්ය පිරිසිදු කිරීම: Keep the chainsaw clean from sawdust, debris, and oil residue.

රූපය: පැත්ත view of the ECHO CS-590 chainsaw, showing the engine housing and air intake area, important for maintenance access.

දෝෂගවේෂණය

පිරිවිතර

• වෙළඳ නාමය: ECHO
• ආකෘතිය: CS-590-20AA
• බලශක්ති ප්රභවය: ගෑස් බලයෙන්
• එන්ජිම විස්ථාපනය: 59.8 සී.සී
• අශ්වබල: 5.3 HP
• දාම දිග: අඟල් 20
• UPC: 743184009338

වගකීම් සහ සහාය

සවිස්තරාත්මක වගකීම් තොරතුරු සඳහා, කරුණාකර ඔබේ නිෂ්පාදනය සමඟ ඇතුළත් කර ඇති වගකීම් කාඩ්පත බලන්න හෝ නිල ECHO වෙත පිවිසෙන්න. website. For technical support, replacement parts, or service, please contact an authorized ECHO service dealer. You can find a dealer near you by visiting the ECHO website or contacting their customer service line.

ECHO නිල Webඅඩවිය: www.echo-usa.com